User`s guide

 129
Administering Digi Connect Devices
Administration from the Command-Line Interface
Administration of Digi Connect devices can also be performed from the command line.
The following table summarizes device-administration tasks and the commands used to
perform them. For descriptions of these commands, see the Digi Connect Family
Command Reference.
Administrative Task Command
Backup/restore a configuration from a
TFTP server on the network
backup
Update firmware
boot
1 Telnet to the device server's
command line interface using a
telnet application or hyperterm.
2 If security is enabled for the device, a
login prompt is displayed. If you do not
know the user name and password,
contact the system administrator who
initially set up the device.
3 Issue the command:
#> boot load=<tftp-server-
ip>:<filename.bin>
where <tftp-server-ip> is the IP address of
the TFTP server that contains the
firmware and where <filename.bin> is the
name of the filename to upload.
Reset configuration to factory defaults
revert
or
boot action=factory
Display system information and statistics info
Reboot the device boot