User`s guide

Administration from the Java Applet Interface
128  Digi Connect Family User’s Guide
Restore the Configuration from a Browser
1 Open a web browser and enter the device server’s IP address in the URL window.
2 If security is enabled for the device, a login prompt is displayed. Enter the user
name and password for the device. If you do not know the user name and password,
contact the system administrator who initially set up the device.
3 Click Factory Default Settings from the main menu.
4 Click Restore.
Display System Information
Display system information gives the model, MAC address, firmware version, boot
version, and POST version of your Digi Connect device. You can also check your memory
available–total, used, and free. It also tracks CPU percent utilization and the uptime.
Under Administration, click System Administration, and select General, GPIO, Serial or
Network for the appropriate information.
Reboot the Device
Some changes require you to save and reboot. Click Reboot and the Reboot button and
wait approximately 1 minute for the reboot to complete.
Enable/Disable Access to Services
As needed, you can enable and disable access to various network services, such as ADDP,
RealPort, SNMP, and Telnet. For example, you may want to disable those services that are
not necessary for running or interfacing with the Digi Connect device. In the Java applet
interface, enabling and disabling network services is done on the Network Services tab of
the Network Configuration page for a device. See "Configure Network Settings" on page
102.