User`s guide

Administration from the Java Applet Interface
126  Digi Connect Family User’s Guide
Reboot the Device
Some changes require you to save and reboot. Click Reboot and the Reboot button and
wait approximately 1 minute for the reboot to complete.
Enable/Disable Access to Services
As needed, you can enable and disable access to various network services, such as ADDP,
RealPort, SNMP, and Telnet. For example, you may want to disable those services that are
not necessary for running or interfacing with the Digi Connect device. In the default web
interface, enabling and disabling network services is done on the Network Configuration
page for a device. See "Enable or Disable Network Services" on page 84.
Administration from the Java Applet Interface
In the Java applet device interface, administration tasks are also organized under
Administration in the main menu. There are fewer choices than in the default Web
interface:
 Backup/Restore: For backing up or restoring a device configuration.
 Restore Factory Defaults: For restoring a device’s configuration to factory
defaults.
 System Information: For displaying system information for the device,
including general device information, current GPIO pin settings, serial line
signals and statistics, and network statistics.
 Reboot: For rebooting the device.
You cannot perform file management tasks or update firmware from the Java applet
interface. If you need to perform such tasks, switch the device interface to the default Web
interface.
Additionally, over time, you may need to enable and disable device access to network
services. See "Enable or Disable Network Services" on page 84.