User`s guide

 125
Administering Digi Connect Devices
2 Press the rest button gently (shown in the illustration below) with a non-conducive,
small diameter tool (such as wood or plastic) with a blunt end (NOT SHARP or the
button could be damaged) to hold down the reset button.
3 Power on the device while holding the rest switch down (about 20 -40 seconds.)
Display System Information
Display system information gives the model, MAC address, firmware version, boot
version, and POST version of your Digi Connect device. You can also check your memory
available -total, used, and free. It also tracks CPU percent utilization and the uptime.
Under Administration click System Administration. and select General, GPIO, Serial or
Network for the appropriate information.
Reset Switch
WAN
RESET