User`s guide

Configuration Through the Command Line
104  Digi Connect Family User’s Guide
 The Alarm List shows all the alarms that are currently defined for a device.
Differences for alarm configuration in the Java applet include:
 Alarms can be configured to be sent as email messages only. They cannot be
sent as SNMP traps. You would need to override the alarm configuration either
by toggling to the default Web UI or issuing a followup set alarm command
from the Command-Line Interface.
 The method for specifying trigger conditions is different from those in the
default web interface. There, each trigger condition has a combo box for
selecting the condition. In the Java applet, conditions are defined by specifying
one of the following values:
– X: Ignore
–1: High
–0: Low
Configure Security Features
To configure security features, click the Security link. Currently, configurable security
features are limited to specifying whether password authentication is required for the Digi
Connect device, and the user name and password required for logging on to the Digi
Connect device.
Configuration Through the Command Line
Configuring Connect devices through the command line consists of entering a series of
commands to set values in the device. For example:
To Configure: Use This Command:
system-identifying information set system
general serial port options set serial
serial TCP and serial UDP set tcpserial and set udpserial