User guide

16 Chapter 3 Setting Up RealPort (COM Port Redirection)
2. Install the RealPort software on your PC. See "Installing RealPort on a
System Running Microsoft Windows Operating System from the CD" on
page 16.
For UNIX RealPort software and documentation, see the Digi web site
(www.digi.com).
Configuring the Device Server for RealPort
1. Access the configuration by opening a web browser and entering the IP
address in the URL address bar.
2. Log on as the root user (User Name root). The default password is
dbps.
3. If this is not a new device server, restore the default
settings by clicking Administration.
Note: Restoring the Digi One device to its factory default settings will clear all
current settings except the IP address settings and the administrator
password.
4. Select Restore Factory Default Settings and click Restore.
5. Click Serial Port > Change Profile
6. Select RealPort and click Apply.
Note: No other serial communication settings are required.
7. Load RealPort driver. See "Installing RealPort on a System Running
Microsoft Windows Operating System from the CD" on page 16
Installing RealPort on a System Running Microsoft Windows Operating System from the
CD
Use this procedure to install RealPort software.
Note: It is recommended that you check the Digi website for the latest RealPort
drivers.
1. Place the CD in the CD drive.
2. If the CD does not start automatically, click Start > Run and in the run
dialog, browse to the root of the CD and then click setup.exe.
3. Click Cancel on the wizard (this will close the Setup
wizard).
4. Click Install Optional Software.
5. Click RealPort.
6. Follow the on-screen prompts and use the Microsoft
Windows Help for assistance.
Note: See the Digi website for UNIX RealPort drivers and documentation.
Installing RealPort on a Windows System from the Web
1. Go to www.digi.com
2. Click Support.