User guide

Chapter 2 Configuring the IP Address 13
1. Access the command line.
2. Issue the following command:
arp -s ip-address mac-address
Example
arp -s 192.168.2.2 00-40-9D-00-00-00
Ping the Digi device using the IP address just assigned.
ping 192.168.2.2
The ping will probably time out before there is a response from the device
server. Wait a few seconds and then ping the device server again. The
device server will respond indicating that the IP address has been
configured.
Testing the IP Address Configuration
Use this procedure to test your IP address configuration.
Prerequisite
This procedure assumes that you have configured the device server with
an IP address.
Procedure
1. Access the command line of a PC or other networked device.
2. Issue the following command:
ping ip-address
where ip-address is the address you assigned to the device server.
Example
ping 192.168.2.2
A reply should be returned.
Changing an IP Address from a Web Browser
Prerequisite
This procedure assumes that the device server already has an IP address
and you simply want to change it.
Procedure
1. Open a web browser and enter the device server’s current IP address in
the URL address bar.
2. When the device server prompts you to log on, specify the following:
• The username is root.
• The default password is dbps.
3. Click Network to access the Network Configuration page.
4. Enter an IP address (and other network-related parameters) and then
click Apply to save the configuration.