Installation guide

set permissions
86 Chapter 2 Command Descriptions
set permissions
Devices
supported
This command is supported in all Digi Connect Family devices. However,
not all options are supported by Digi Connect devices. For example,
s-ethernet is only supported in the wired devices.
Purpose Used to set permissions associated with various services and command-
line interface (CLI) commands, or display current permission settings.
Commands without permissions
There are no permissions associated with the following commands:
•close
• exit
•help
•info
•quit
Permissions for the “revert” command
For the “revert” command, the permissions associated with the various
“set” commands are used, except for the “revert all” command variant,
which uses a different mechanism that bypasses the individual “set”
commands.
Required
permissions
Permissions must be set to “set permissions s-permissions=read” to
display permissions, and “set permissions s-permissions=rw” to display
and change permissions. When permissions are set to
“set permissions s-permissions=rw,” a user cannot set another user’s
permission level higher than their own level, nor can they raise their own
permission level.