Installation guide

set network
84 Chapter 2 Command Descriptions
set network
Devices
supported
This command is supported in all Digi Connect Family devices.
Purpose Used to set general network configuration options and display current
network configuration options.
Required
permissions
Permissions must be set to “set permissions s-network=read” to display
network configuration attributes, and “set permissions s-network=rw” to
display and set network configuration attributes. See "set permissions" on
page 86 for details on setting user permissions for commands.
Syntax Set general network configuration options
set network [gateway=gateway ip]
[ip=device ip]
[submask=device submask]
[static={on|off}]
[dhcp={on|off}]
[autoip={on|off}]
[idle=10-86400]
[probe_count=5-30]
[probe_interval=10-75]
[garbage_byte={on|off}]
[override_dhcp={on|off}]
The keepalive options (“idle,” “probe_count,” “probe_interval,”
“garbage_byte,” and “override_dhcp”) should be configured for various
services that are configured by “set service keepalive={on|off},” or clients
such as autoconnect (“set autoconnect keepalive={on|off}”).
Display current network configuration options
set network
Options gateway=gateway ip
Sets the network gateway IP address.
ip=device ip
Sets the device IP address when DHCP is off. This option is only
applicable if the “static” option is set to “on.”
submask=device submask
Sets the device submask address when DHCP is off. This option is only
applicable if the “static” option is set to “on.”
The following three IP address options have a precedence. That is, if all
three options are turned on, the order of precedence is: “static,” “dhcp,”
“autoip.”
static={on|off}
When enabled, the device uses the specified IP address, gateway
address, and submask. The default is off.
dhcp={on|off}
When enabled, the device attempts to use the DHCP protocol to find an