Installation guide

set nat

Chapter 2 Command Descriptions 83

Examples Enable NAT and specify settings for port forwarding entry 1

This example command will enable the forwarding of TCP packets

received at port 4009 of the public (PPP) interface of the device server, to

TCP port 7008 of the host whose IP address is 143.191.1.228 on the

Ethernet side of the device server.

set nat enabled=on poenabled1=on poproto1=tcp poexternal=4009

pointernal=7008 poip=143.191.1.228

Display NAT and port/protocol forwarding settings

set nat