Installation guide

set mgmtnetwork
78 Chapter 2 Command Descriptions
set mgmtnetwork
Devices
supported
This command is supported in all Digi Connect Family devices.
Purpose Used to set or display the Connectware Device Protocol network settings.
Required
permissions
To use this command, permissions must be set to one of the following:
• For a user to display the Connectware Device Protocol network
settings: “set permissions s-mgmtnetwork =read”
• For a user to display and set Connectware Device Protocol network
settings: “set permissions s-mgmtnetwork =rw”
See "set permissions" on page 86 for details on setting user permissions
for commands.
Syntax Configure Connectware Device Protocol network settings
set mgmtnetwork
[networktype={modemppp|ethernet|802.11}]
[connectionmethod={auto|none|mt|mdh|proxy}]
[proxyaddress=string]
[proxyport=port]
[proxylogin=string]
[proxypassword=string]
[proxypersistentconnection={on|off}]
[mtrxkeepalive=time]
[mttxkeepalive=time]
[mtwaitcount=count]
[mdhrxkeepalive=time]
[mdhtxkeepalive=time]
[mdhwaitcount=count]
Display Connectware Device Protocol network settings
set mgmtnetwork
Options [networktype={modemppp|ethernet|802.11}
Used to specify which type of network to which this instance applies.
modemppp
This instance applies to the modem PPP network.
ethernet
This instance applies to the ethernet network.
802.11
This instance applies to the 802.11 network.