Installation guide

set mgmtconnection
Chapter 2 Command Descriptions 75
timedperiod=period
For a timed connection, this option is used to specify the time interval in
minutes between the device server's attempts to connect to the
Connectware Manager server. If a device server is already in a
connection to a Connectware Manager when the time interval expires, it
will not start a new connection at that time. Rather, the device server will
start a new timed period timer, and it will again check whether it needs to
connect to the Connectware Manager when that new timer expires.
timedoffset={immediate|oneperiod|randomtime}
For a timed connection, this option is used to specify when the first timed
connection (to a Connectware Manager) should be attempted after the
device server boots.
immediate
Attempt to connect immediately.
oneperiod
Wait one full timed period, then attempt to connect.
randomtime
Wait some random interval of time, between 0 and the full timed
period, then attempt to connect.immediate
lkaupdateenabled={on|off}
In conjunction with a server-initiated connection, this option is used to
enable a connection to a Connectware Manager server for the purpose
of informing that server of the IP address of the device server. This
permits the Connectware Manager to connect back to the device server,
or to dynamically update a DNS with the IP address of the device.
on
Enables "last known address" connections to the Connectware
Manager.
off
Disables "last known address" connections to the Connectware
Manager.
clntreconntimeout={none|timeout}
Used to specify the client reconnect timeout value in seconds. If client-
initiated connections are enabled, the device server will wait this amount
of time after a connection to the Connectware Manager is ended, and
then it will reconnect to the Connectware Manager. The keyword “none”
turns off the timeout feature.
svraddr[1-8]=string
Used to specify one of eight possible Connectware Manager server
addresses. When the device server attempts to connect to a
Connectware Manager, it tries the server addresses in this list in the
order 1-8.
secidx[1-8]=index
Used to link a server address with a Device Security entry.