Installation guide

Quick Reference for Configuring Features
Chapter 1 Introduction 7
Modem emulation "set pmodem" on page 102
"set serial" on page 116
Chapter 3, "Modem Emulation Commands" on
page 151
Network access control "set accesscontrol" on page 44
Network configuration "set network" on page 84
Network services, enabling and
disabling
"set service" on page 118
Ping a host or device "ping" on page 36
Point to Point Protocol (PPP) "set pppoutbound" on page 104
Port buffering "display buffers" on page 21
"set buffer" on page 55
RealPort (COM port redirection) See the RealPort Installation Guide for details on
configuring this feature.
Remote login (rlogin) "rlogin" on page 42
Network Address Translation
(NAT) and port forwarding
configuration
"set nat" on page 81
"set forwarding" on page 62
Security/access control features:
Control access to inbound ports "set service" on page 118
Serial port configuration:
Enable/disable command-line
access
"set term" on page 126
General serial port
communication options
"set serial" on page 116
Port profiles "set profile" on page 110
RCI serial mode "set rciserial" on page 113
RTS Toggle "set rtstoggle" on page 114
TCP serial connections "set tcpserial" on page 123
UDP serial characteristics "set udpserial" on page 127
Automatically connect to a server
or network device
(autoconnection)
"set autoconnect" on page 51
"set serial" on page 116
"set tcpserial" on page 123
Feature/Task Commands