Installation guide

set forwarding

62 Chapter 2 Command Descriptions

set forwarding

Devices

supported

This command is supported in Digi Connect WAN devices only.

Purpose Enables or disables IP routing, or forwarding of IP datagrams, between

network interfaces. IP forwarding must be enabled to allow the Network

Address Table and port forwarding features to work properly.

Required

privileges

To use this command, permissions must be set to one of the following:

• For a user to display the forwarding settings:

“set permissions s-router=read”

• For a user to display and set forwarding settings:

“set permissions s-router=rw”

See "set permissions" on page 86 for details on setting user permissions

for commands.

Syntax Set forwarding settings

set forwarding [ipforwarding={on|off}]

Display forwarding settings

set forwarding

Options ipforwarding={on|off}

Enables or disables IP forwarding.

Enables IP forwarding.

off

Disables IP forwarding.

Examples Enable IP forwarding

set forwarding ipforwarding=on