Installation guide

Quick Reference for Configuring Features
6 Chapter 1 Introduction
Quick Reference for Configuring Features
The following table shows common features that can be configured from
the command line, and the commands used to configure each feature.
Feature/Task Commands
Configure Alarms "set alarm" on page 46
Configuration management/Administration:
Backup/restore a configuration
from a TFTP server on the
network
"backup" on page 14
Update firmware "boot" on page 15
Reset configuration to factory
defaults
"revert" on page 39
boot action=factory (see "boot" on page 15)
Reboot the device "boot" on page 15
Connectware Device Protocol
configuration settings
"set devicesecurity" on page 57
"set mgmtconnection" on page 74
"set mgmtglobal" on page 77
"set mgmtnetwork" on page 78
Custom menus "set menu" on page 69
Display current configuration
settings in a device
"show" on page 144
Display device statistics "info" on page 25
Display device status "display" on page 19
"status" on page 147
"who" on page 149
Forwarding "set forwarding" on page 62
General Purpose Input/Output
(GPIO) pins
"set gpio" on page 63
"set alarm" on page 46
Help on device commands "help" on page 24
Host name for a device (Specify
a name for the device)
"set host" on page 68
Manage connections "connect" on page 18
"reconnect" on page 38
"rlogin" on page 42
"telnet" on page 148
"who" on page 149
"close" on page 17
"kill" on page 33