Installation guide

set accesscontrol

Chapter 2 Command Descriptions 45

subnip[1-32]=ipaddress

Used to specify up to 32 subnet IP addresses. Any IP address in these

subnets will be allowed to access this device server.

subnmask[1-32]=mask

Used to specify a subnet mask associated with one of the 32 subnet IP

addresses.

Examples Set access control settings

set accesscontrol enabled=on addrip1=143.191.1.228

Set access control for a specific subnet

This command will allow any IP address in the 143.191.2.0 subnet

(netmask 255.255.255.0) to access this device server:

set accesscontrol enabled=on subnip1=143.191.2.0

subnmask1=255.255.255.0

Display access control settings

set accesscontrol