Installation guide

revert
40 Chapter 2 Command Descriptions
devicesecurity
Reverts the Connectware Device Protocol device security settings
configured by the “set devicesecurity” command.
forwarding
Reverts the port-forwarding settings configured by the “set forwarding”
command.
gpio
Reverts the GPIO settings configured by the “set gpio” command.
host
Reverts the host name set by the “set host” command.
menu
Reverts the custom menu settings configured by the “set menu”
command.
mgmtconnection
Reverts the Connectware Device Protocol connection settings
configured by the “set mgmtconnection” command.
mgmtglobal
Reverts the Connectware Device Protocol global settings configured by
the “set mgmtglobal” command.
mgmtnetwork
Reverts the Connectware Device Protocol network settings configured by
the “set mgmtnetwork” command.
nat
Reverts the Network Address Translation (NAT) and port/protocol
forwarding settings configured by the “set nat” command.
network
Reverts the network settings, configured by the “set network” command,
and the wireless configuration settings, configured by the “set wlan”
command.
pmodem [port=range]
Reverts the modem emulation settings, configured by the “set pmodem”
command.
pppoutbound [port=range]
Reverts the Point-to-Point Protocol (PPP) outbound connection settings,
configured by the “set pppoutbound” command.
profile [port=range]
Reverts the profile settings configured by the “set profile” command.
serial [port=range]
Reverts the serial settings configured by the “set serial” command.
service
Reverts the service settings configured by the “set service” command.
snmp
Reverts the SNMP settings configured by the “set snmp” command.