Installation guide

revert

Chapter 2 Command Descriptions 39

revert

Devices

supported

This command is supported in all Digi Connect Family devices.

Purpose Sets a particular group of a devices’ settings to its default values.

If you enter "revert user," "revert group," or "revert permissions," a

message is displayed indicating that those settings cannot be reverted

individually, and instead must be reverted all together at the same time via

the “revert auth” command. The “revert auth” command (revert

authentication and authorization) reverts all users, all groups, and all

permissions at the same time.

Required

permissions

No “set permissions” option is required for all “revert” command variants

except “revert all.” The permissions used by the various “set” commands

apply to the various “revert” command variants. “revert all” uses a different

mechanism that bypasses the individual “set” commands, and therefore

has its own permissions. To execute the “revert all” command, a user must

have permissions set to “set permissions revert-all=execute”. See "set

permissions" on page 86 for details on setting user permissions for

commands.

Syntax

buffer [port=range]|

|pppoutbound [port=range]|

profile [port=range]|serial [port=range]

udpserial [port=range]|user|wireless]

Options all

Reverts everything except network settings.

alarm

Reverts the alarm settings configured by the “set alarm” command.

accesscontrol

Reverts the access control settings configured by the “set accesscontrol”

command.

auth

Reverts the permission settings configured by the “set permissions”

command, the user settings configured by the “set user” command, and

group settings, configured by the “set group” command.

autoconnect [port=range]

Reverts the Autoconnect settings configured by the “set autoconnect”

command.

buffer [port=range]

Reverts the port-buffering settings configured by the “set buffer”

command.