Installation guide

info
Chapter 2 Command Descriptions 25
info
Devices
supported
This command is supported in all Digi Connect Family devices.
Purpose This command prints out statistical information about a device. Command
options allow display of the following categories of statistics:
• Device statistics
• Ethernet statistics
• ICMP statistics
• IP statistics
• Serial statistics
• TCP statistics
• UDP statistics
• WLAN statistics (For wireless devices only)
The statistics in these tables are those gathered since the tables were last
cleared.
Syntax info {device|ethernet|icmp|ip|serial|tcp|udp|wlan}
Options For a description of the statistics displayed by all these options, see
“Results” on the following page.
device
Displays statistics from the device table. This information includes
device-model information, MAC address, current Boot and POST code,
firmware, memory usage, utilization, and uptime. The information
displayed by this option is the same as that displayed by the
“display device” command (see "display" on page 19).
ethernet
Displays statistics from the Ethernet table.
icmp
Displays statistics from the ICMP table.
ip
Displays statistics from the IP table.
serial
Displays statistics from the serial table. For descriptions of these
statistics, see "Results" on page 26.
tcp
Displays statistics from the TCP table.
udp
Displays statistics from the UDP table.
wlan
Displays statistics from the wireless Ethernet (wlan) table.