Installation guide

display
20 Chapter 2 Command Descriptions
nat
Displays Network Address Table (NAT) status information.
pppstats
Displays Point-to-Point Protocol (PPP) status information.
serial
Displays serial modem signals (DTR, RTS, CTS, DSR, DCD).
uptime
Displays amount of time since the device was booted.
version
Displays boot, POST and EOS firmware version information and Digi part
numbers for those items.
wlan
Displays typical wireless LAN (WLAN) parameters for wireless devices.
Example display device
See also The “display” command’s focus is on real-time information. In contrast, the
“info” command displays statistical information about a device over time,
while the “status” command displays the status of outgoing connections
(connections made by “connect,” “rlogin,” or “telnet” commands). For more
information, see these commands:
• "info" on page 25.
• "status" on page 147