Installation guide

display
Chapter 2 Command Descriptions 19
display
Devices
supported
This command is supported in all Digi Connect Family devices.
Purpose Use the display command to status information for a device. Command
options allow for displaying a variety of status information, including:
• General product information, including the product name, MAC
address, boot, post, and firmware versions, memory usage, utilization,
and uptime, or the amount of time since the device was last booted.
• Access control status information
• GPIO signals.
• Memory usage information only.
• Mobile (cellular modem) status information.
• Network Address Table (NAT) status information
• Point-to-Point Protocol (PPP) status information
• Serial modem signals (DTR, RTS, CTS, DSR, DCD).
• Uptime information only.
• Boot, POST and EOS firmware version information and Digi part
numbers for those items
• Typical wireless LAN (WLAN) parameters for wireless devices.
Required
permissions
Permissions must be set to “set permissions display=execute” to use this
command. See "set permissions" on page 86 for details on setting user
permissions for commands.
Syntax display
{accesscontrol|device|gpio|memory|mobile|nat|pppstats|serial|
uptime|version|wlan}
Options accesscontrol
Displays access control status information.
device
Displays general product information including product name, MAC
address, boot, post, and firmware versions, memory usage, utilization,
and uptime. The information displayed by this option is the same as that
displayed by the “info device” command (see "info" on page 25).
gpio
Displays GPIO signals.
memory
Displays general memory, network memory, and streams memory
usage.
mobile
Displays mobile (cellular modem) status information. (This option applies
to Digi Connect WAN and Digi Connect RG devices only.)