Installation guide

status
Chapter 2 Command Descriptions 147
status
Devices
supported
This command is supported in all Digi Connect Family devices.
Purpose Displays the current list of sessions. This includes any session that was
created by a connect, rlogin, or telnet command. Typically, the status
command is used to determine which sessions to close.
Required
permissions
Permissions must be set to “set permissions status=read” or
“set permissions status=rw” to use this command. See "set permissions"
on page 86 for details on setting user permissions for commands.
Syntax status [range] [session_number]
Options range
The range of sessions to view.
session_number
An index number identifying the session number to view.
Examples status
See also • "connect" on page 18
• "close" on page 17, for information on ending a connection.
• "rlogin" on page 42
• "telnet" on page 148
The “status” command displays the status of outgoing connections
(connections made by “connect,” “rlogin,” or “telnet” commands). In
contrast, the “display” command displays real-time information about a
device, while the “info” command displays statistical information about a
device over time. For more information, see these commands:
• "display" on page 19
• "info" on page 25.
• "who" on page 149