Installation guide

show
Chapter 2 Command Descriptions 145
port=range
Identifies a particular serial port. Optional on a single-port device.
range=range
A configuration table entry or range of entries.
Examples Display network configuration settings
show network
nat set nat N N
network set network N N
permissions set permissions N N
pmodem set pmodem Y N
pppoutbound set pppoutbound Y N
profile set profile Y N
rciserial set rciserial N N
route The IP routing table.
This command is not
associated with a “set”
command.
NN
rtstoggle set rtstoggle Y N
serial set serial Y N
service set service N Y
snmp set snmp N N
system set system N N
tcpserial set tcpserial Y N
term set term
udpserial set udpserial Y Y (when
specifying
UDP serial
destinations)
user set user N Y
versions This command shows
firmware version
information. It is not
associated with a “set”
command.
NN
wlan set wlan N N
Option
Displays settings
configured by
Works w/
port option
Works w/
range
option