Installation guide
show
144 Chapter 2 Command Descriptions
show
Devices
supported
This command is supported in all Digi Connect Family devices.
Purpose Displays the current settings in a device, including current configuration
settings, boot code loaded in the device, and the effects of commands
issued to the device.
Required
permissions
For this command to display current device settings, the various “set”
commands must have be set to either “read” or “r-self,” depending on the
available permissions for the commands. See "set permissions" on page
86 for details on setting user permissions for commands.
Syntax show option [port=range] [range=range]
Options option
Specifies which settings in the device to show. The following options can
be specified. The use of the “port” and “range” options on the show
command depends on whether the command that was used to configure
the settings uses the “port” and “range” options as well.
Option
Displays settings
configured by
Works w/
port option
Works w/
range
option
accesscontrol set accesscontrol N N
alarm set alarm N Y
arp The arp table. This
option is not
associated with a “set”
command.
NN
autoconnect set autoconnect Y N
buffer set buffer Y N
devicesecurity set devicesecurity N N
ethernet set ethernet N N
forwarding set forwarding N N
gpio set gpio N Y
group set group N N
host
set host N N
menu set menu N Y
mgmtconnection set mgmtconnection N Y
mgmtglobal set mgmtglobal N N
mgmtnetwork set mgmtnetwork N Y