Installation guide

set wlan
Chapter 2 Command Descriptions 139
Syntax Configure wireless settings
set wlan
[protmode={bss|ibss_create|ibss_join|any}]
[channel={0|1-14}]
[ssid=string]
[authentication={[open],[sharedkey],[wep_auth],[wpa_psk],
[wpa_auth],[leap],[any]}
[encryption={[open],[wep],[tkip],[ccmp],[any]}]
[outer_eap={[peap],[tls],[ttls],[any]}]
[inner_eap={[gtc],[md5],[mschapv2],[otp],[chap],[mschap],
[ttls_mschapv2],[pap],[any]}]
[options={[diversity],[short_preamble],[verify_cert]}]
[username=string]
[password=string]
[psk=string]
[wepmode={64bit|128bit}]
[wepindex=1-4]
[wepkeyN=hex_string]]
[country=string]
[maxtxrate={1mb|2mb|5.5mb|11mb}]
[txpower={16dbm|14dbm|12dbm|10dbm|8dbm|6dbm}]
Display wireless settings
set wlan
Options Regarding command options “authentication encryption,” “outer_eap,”
“inner_eap,” and “options:” These options have multiple values. More than
one value may be specified for each option to indicate the set of allowed
values. The actual value used will be determined by the capabilities of the
wireless network.
protmode={bss|ibss_create|ibss_join|any}
Used to change the operation mode in which the device will work.
bss
Indicates that the device should join an access point.
ibss_create
Indicates the device will attempt to first join an Independent Basic
Service Set (IBSS), and create one if it is unable to find one.
ibss_join
Indicates the device should attempt to join an IBSS or self-contained
wireless network.
any
Enables all operation modes.
Typically, the operation mode is “bss.” The default is “bss.”
channel={0|1-14}
Sets the frequency channel that the wireless Ethernet radio will use. A
value of 0 indicates that the device will scan all frequencies until it finds
one with an available access point or wireless network it can join. The
default value is 10.