Installation guide

set user
Chapter 2 Command Descriptions 131
set user
Devices
supported
This command is supported in all Digi Connect Family devices.
Purpose Used to:
• Add users for access to this Digi device. Up to 32 users can be defined.
• Associate a user with a group. A user can be associated with up to two
groups.
• Disassociate a user from a group.
• Remove users.
• Change user configuration attributes.
• Display user configuration attributes.
Default permissions for a new user
When a new user is created, it is given a set of default permissions. Once a
user is created, an administrator can adjust permissions up or down as
needed. Default permissions for a new user are as follows. For more
information on user permissions, see "set permissions" on page 86.
• none: for backup, boot, connect, display, buffers, kill, s-alarm, s-gpio,
s-permissions, s-pmodem, s-rciserial, s-snmp, status, webui, filesys,
s-idle, s-panic, revert-all, s-trace, s-wlan, s-menu, s-profile
• execute: For reconnect, rlogin, telnet, who, ping.
• read: access, s-ethernet, s-group, s-network, s-serial, s-service,
s-system, s-trane, s-user
• r-self: autoconnect, rtstoggle, tcpserial, udpserial
• rw-self: newpass
Required
permissions
To use this command, permissions must be set to one of the following:
• For a user to display user configuration attributes:
“set permissions s-user=read”
• For a user to display and set user configuration attributes:
“set permissions s-user=rw”
See "set permissions" on page 86 for details on setting user permissions
for commands.