Installation guide

set rtstoggle
114 Chapter 2 Command Descriptions
set rtstoggle
Devices
supported
This command is not supported in Digi Connect WAN devices.
Purpose Used to:
• Enable or disable RTS toggle on a given serial port. RTS toggle is used
to raise RTS when sending data.
• Display current RTS toggle settings.
Required
permissions
To use this command, permissions must be set to one of the following:
• For a user to display the RTS toggle settings for the line on which they
are logged in: “set permissions s-rtstoggle=r-self”
• For a user to display the RTS toggle settings for any line:
“set permissions s-rtstoggle=read”
• For a user to display and set the RTS toggle settings for the line on
which they are logged in: “set permissions s-rtstoggle=rw-self”
• For a user to display the RTS toggle settings for any line, and set RCI
serial settings for the line on which the user is logged in:
“set permissions s-rtstoggle=w-self-r”
• For a user to display and set the RTS toggle settings on any line:
“set permissions s-rtstoggle=rw”
See "set permissions" on page 86 for details on setting user permissions
for commands.
Syntax Enable or disable RTS toggle
set rtstoggle port=range [state={on|off}]
[predelay=delay] [postdelay=delay]
Display current RTS toggle settings
set rtstoggle [port=range]
Options port=range
Used to specify the serial port. Optional on a single-port device.
state={on|off}
Used to enable or disable the RTS toggle feature.
on
Enables the RTS toggle feature.
off
Disables the RTS toggle feature.
The default is “off.”