Installation guide

set profile
Chapter 2 Command Descriptions 111
Required
permissions
To use this command, permissions must be set to one of the following:
• For a user to display the profile settings for the line on which they are
logged in: “set permissions s-pmodem=r-self”
• For a user to display the profile settings for any line: “set permissions s-
pmodem=read”
• For a user to display and set the profile settings for the line on which
they are logged in: “set permissions s-pmodem=rw-self”
• For a user to display the profile settings for any line, and set modem
emulation settings for the line on which the user is logged in:
“set permissions s-pmodem=w-self-r”
• For a user to display and set the profile settings on any line:
“set permissions s-pmodem=rw”
See "set permissions" on page 86 for details on setting user permissions
for commands.
Syntax Configure port profile settings
set profile port=port profile=profile
Display current port profile settings for all available serial ports
set profile
Display current port profile settings for a particular serial port
set profile port=port
Options port
The serial port number or range of serial ports associated with the port
profile. Required when configuring port profiles.
profile
The port profile to use for the serial port. Required when configuring port
profiles. Choosing a particular port profile causes the serial port’s
configuration to be reset to defaults, and then for the default settings for
that port profile to take effect.
Depending on the port-profile choices available for the device, the value
of “profile” can be one of the following:
console_management
Associates the Console Management port profile with the port. Not
supported in Digi Connect WAN.
modem_emulation
Associates the Modem Emulation port profile with the port. Not
supported in Digi Connect WAN.
realport
Associates the RealPort port profile with the port.
tcp_sockets
Associates the TCP Sockets port profile with the port.