Installation guide

set pppoutbound
104 Chapter 2 Command Descriptions
set pppoutbound
Devices
supported
This command is supported in Digi Connect WAN and Digi Connect RG
devices only.
Purpose Configures Point-to-Point Protocol (PPP) outbound connections, or
displays current PPP outbound settings.
Required
permissions
To use this command, permissions must be set to one of the following:
• For a user to display the pppoutbound settings:
“set permissions s-ppp=read”
• For a user to display and set pppoutbound settings:
“set permissions s-ppp=rw”
See "set permissions" on page 86 for details on setting user permissions
for commands.
Syntax Configure PPP outbound connections
set pppoutbound port=range
[state={enabled|disabled}]
[auth_method={none|PAP|CHAP|both}]
[passive={on|off}]
[remote_address={negotiated|ip_address}]
[local_address={negotiated|ip_address}]
[address_mask=ip_address_mask]
[default_gateway={yes|no}]
[protocol_compression={on|off}]
[address_compression={on|off}]
[header_compression={on|off}]
[lcp_keepalive={on|off}]
[lcp_ka_quiet_time=(10-86400 seconds)]
[lcp_ka_max_missed_replies={(2-255|0=ignore missed replies)}]
[asyncmap=hex_string]
[chap_id=chap_id]
[chap_key=chap_key]
[pap_id=pap_id]
[pap_password=pap_password]
[mru=256-1500]
[mtu=256-1500]
[n{1-4}=phone_number]
[redial_attempts=attempts]
[redial_delay=delay]
[rx_idle_timeout=timeout]
[tx_idle_timeout=timeout]
[init_script=chat_script]
[dial_script=chat_script]
[login_script=chat_script]
Display PPP outbound settings
set pppoutbound