Installation guide

set pmodem
102 Chapter 2 Command Descriptions
set pmodem
Devices
supported
This command is not supported in Digi Connect WAN devices.
Purpose Used to:
• Configure various options for modem emulation over TCP/IP.
• Display current modem-emulation settings.
Required
permissions
To use this command, permissions must be set to one of the following:
• For a user to display the modem emulation settings for the line on which
they are logged in: “set permissions s-pmodem=r-self”
• For a user to display the modem emulation settings for any line:
“set permissions s-pmodem=read”
• For a user to display and set the modem emulation settings for the line
on which they are logged in: “set permissions s-pmodem=rw-self”
• For a user to display the modem emulation settings for any line, and set
modem emulation settings for the line on which the user is logged in:
“set permissions s-pmodem=w-self-r”
• For a user to display and set the modem emulation settings on any line:
“set permissions s-pmodem=rw”
See "set permissions" on page 86 for details on setting user permissions
for commands.
Syntax Configure modem emulation
set pmodem port=range [state={on|off}] [telnet={on|off}]
Display current modem-emulation settings
set pmodem [port=range]
Options port=range
Used to specify the serial port. Optional on a single-port device.
state={on|off}
Used to enable or disable modem emulation on a given serial port.
on
Enables modem emulation.
off
Disables modem emulation.
The default is “off.”