International Network Device User's Guide Digi CM

Configuring Port Clustering
106 Chapter 13
6. Select the Auto Config button and the Master Digi CM automatically imports
the configuration of the Slave serial ports to the Master Digi CM.
The following figure displays serial port configuration imported from a slave
unit.
Note: When changing the protocol or authentication on the slave make sure to re-run
"auto config" on the master.
7. Choose Save & apply.
Note: If Auto Config fails, Clear your cache (delete temporary Internet files) under Tools
> Internet Options on the tool bar.
Configuring Slave Ports on the Master Unit Manually
If you do not use Auto Config you may set the port numbers to any range of
numbers.
1. Enter the IP address that you wish to configure.
2. Select Enable from the drop down menu and enter the number of ports.