Specifications

90 DC-200/300 Operation Manual

7.4 Manual Printing of Labels

You can print a label or receipt for a single transaction in Operation Mode. The format that will be printed is

determined by the Label Format number that was stored with the Item Code during Item Code entry (see

Section 6.1.2).

Notes:

• Before proceeding, make sure that SPEC43 SELECT RECEIPT PRINTING OR LABEL PRINTING is set to the type of stock you

want to print on and that the built-in printer is loaded with the correct stock.

• SPEC 50 SELECTION OF LABEL AND RECEIPT PRINTING OPERATION also determines whether printing can be done during

all operations or just in or out operations. The default is “0: ALL OPERATION”.

• If printing labels in peel-off mode, the message “PLEASE PEEL LABEL” will appear after you press the * REPRINT key if the

previous label remains at the dispenser. You can print another label without removing the previous label by setting SPEC 48 PEEL

SENSOR FUNCTION to “0: Disable”.

7.4.1 Issuing an Item Label or Receipt

1. At the stand-by screen, enter an item code and press the CODE key to recall the item’s information from

the scale’s memory.

2. Place the product on the scale platter.

3. Press the

* REPRINT key to issue a label or receipt for this individual item.

4. Remove the product from the platter and enter another item code or press the

CLEAR key to return to the

stand-by screen.

7.4.2 Issuing a Total Label or Receipt

Note: SPEC34 PRINT WHEN PRESS +/– KEY determines whether the scale prints during accumulation whenever the + (Plus) or

– (Minus) keys are pressed. The default is “0: Disable”, meaning that you must press the * REPRINT key to print.

1. At the stand-by screen, enter an item code and press the CODE key to recall the item’s information from

the scale’s memory.

2. Place the product on the scale platter.

3. Press the

+ (Plus) key to enter the total mode. The memory annunciator

will illuminate.

4. Press the

* REPRINT key to print a total label or receipt.

5. Remove the product from the platter and enter another item code or press the

CLEAR key to return to the

stand-by screen.