Specifications

Printing Labels (DC-300 only) 81
How to Program a Logo File
1. Press MODE key until the display shows ITEM CODE PROGRAMMING. The S annunciator, indicating the
programming mode, will illuminate.
2. Press the
+ (plus) key eight times to reach the LOGO PROGRAMMING mode.
3. Enter a new logo number between 1 and 4 and press the
* REPRINT key. If you enter a logo number that
has already been programmed into memory the screen will display the existing data for that logo.
4. At the
ENTER X (DOT): prompt, enter the horizontal position out of 128 squares at which you want to start
programming (ex.: entering a 7 will put you at the 7th square from the left). Press the
* REPRINT key to
move to the next prompt.
5. At the
ENTER Y (DOT): prompt, enter the row out of 64 at which you want to start programming. (ex.:
entering a 1 will put you at the bottom-most row.) Press the
* REPRINT key to move to the next prompt.
6. Enter the first dot by entering a
1. The cursor will automatically move to the next square to the right. You
can enter ones for squares to be filled and zeros for squares to be left clear. If you reach the end of a row,
the cursor will automatically move to the leftmost square of the next row up. At any time you can move
to the next line up by pressing the
* REPRINT key. Other navigation can be done by using the keys shown
in Table 7-3 on page 80.
7. If at any time you want to go back to the entry screen where you can again specify an X and Y location
to begin further programming, press the
– (minus) key twice. Enter a horizontal position, followed by a
vertical position. To keep either one without change, press the * REPRINT key. To save the new data,
press the
CODE key. To exit without saving the data, press the PIECES key followed by the CLEAR key.
How to Delete a Logo File
1. Press MODE key until the display shows ITEM PROGRAMMING MODE. The S annunciator, indicating the
programming mode, will illuminate.
2. Press the
+ (plus) key eight times to reach the LOGO PROGRAMMING mode.
3. Enter the logo number between 1 and 4 for the logo you will like to delete and press the
– (minus) key.
4. Press the
CLEAR key to delete the logo file or press TARE key to cancel the deletion.
5. To return to the stand-by screen, press the
MODE key three times.