Specifications

80 DC-200/300 Operation Manual
You can also move manually around the grid using the keys shown below.
Printing the Logo Files
If this is the first time you are programming in a logo, you can go directly to How to Program a Logo File below.
If you want to check what logos are already programmed into the scale and see what logo files are still available,
follow the instructions below to print a report of the logo file. You can only print a logo report for a single file.
There is no report available for all the logo files at once.
Note: SPEC 58 - LOGO PRINTING sets which logo file will print on labels with space for a logo. See Section 3.0 Dealer
Configuration Settings on how to change this specification if needed.
Before printing the report, please make sure that the DC-300 printer is loaded with receipt paper rather than
labels (see Section 7.1.4 on setting up the printer).
1. Press
MODE key until the display shows ITEM CODE PROGRAMMING. The S annunciator, indicating the
programming mode, will illuminate.
2. Press the
+ (plus) key eight times to reach the LOGO PROGRAMMING mode.
3. To print a logo report, enter the logo number for the existing logo file you want to print and press the
TARE key. To stop the printing, press the FEED key.
Key Description
Clear a dot
Fill a dot
Move the cursor to the left
Move the cursor to the right
Move the cursor up
Move the cursor down
Move up to the first dot in the next line
Store the data
Table 7-3. Programming Keys