Specifications

76 DC-200/300 Operation Manual
Figure 7-22. Address Report
4. To return to the Stand-by screen, press the MODE key three times.
How To Program an Address File
1. Press MODE key until the display shows ITEM PROGRAMMING MODE. The S annunciator, indicating the
programming mode, will illuminate.
2. Press the
+ (plus) key four times to reach the address programming mode.
3. Enter a new address number between 1 and 16 and press the
* REPRINT key. If you enter an address
number that has already been programmed into memory, the screen will display the existing address
information for that address number.
4. The scale will now prompt you to select a label format for this address (see Section 7.1.2 for available
label formats). Press the
<< or >> keys to scroll through the available label formats. If you try to save an
address on a label format which has no print area for an address, you will get a warning beep, the screen
will display
NO PRINT AREA briefly and then return to the option to choose a label format. Press the *
REPRINT key to save the label format.
5. At the blinking cursor, enter the first line of data for this address using the alphanumeric keyboard or
numeric keypad. To the left of the cursor the display will show the font size on the current label default
format, the number of characters remaining that you can enter at this font size, and what line you are on.
(e.g. S4/53/01 would indicate that there are 53 characters left that you can enter on line 1 of the name file
at an S4 font size.) You may also use the ASCII codes shown in Table 12-17. Press the
* REPRINT key to
move to the next line.
6. Repeat Step 3 to enter data on lines 2 through 8 for this address, if desired, pressing the
* REPRINT key to
store each line after entering it. At any point that you are finished you can save your data and exit by
pressing the
CODE key. To exit without saving the data, press the PIECES key followed by the CLEAR
key.
7. To return to the stand-by screen, press the
MODE key three times.