Specifications

Printing Labels (DC-300 only) 73
7.1.7 Adjusting Printing Position
If the thermal print head gets misaligned vertically, the vertical position can be adjusted using the procedure
below.
At the stand-by screen, hold down the
REZERO key while entering 514 to enter the adjust printing position mode.
The following will appear on the display:
Print positions are measured in dots, where 1 vertical dot = 0.155mm. To adjust the print position upward, enter
the number of dots from the numeric keypad. To adjust the print position downward, enter the number of dots
from the numeric keypad the press the
– (minus) key. Finally, press the CODE key to store the new value and exit
to the stand-by screen. To exit the adjust printing position mode without making any changes, press the
TARE
key.
7.1.8 Turning On and Off the Internal Printer
The DC-300’s built in printer can be enabled (turned on) or disabled (turned off) from the keyboard. At the
stand-by screen, press the
* REPRINT key while holding down the REZERO key. The following will appear on the
display:
Pressing the
* REPRINT key while holding down the REZERO key again will re-enable the built-in printer,
showing the following on the display: