Specifications

46 DC-200/300 Operation Manual

3. To exit the view item information mode and return to the Stand-by or operation mode, press the CLEAR

key.

5.11.3 Re-Computing Item Code Unit Weight

Note: If you want the accuracy percentage of the recomputing to be displayed during the calculation, be sure that SPEC 9

DISPLAY ACCURACY UNIT WEIGHT CALCULATION DURING RECOMPUTING is set to “1: YES”.

1. Recall item code from memory (refer to Section 5.11.5).

2. Place items to be counted on the scale platter until the

RECOMPUTING annunciator lights up.

3. Press the

PIECES key for recomputing the unit weight. (This may take a few seconds.)

4. Press the

UNIT WEIGHT key to store the new unit weight into memory. To exit without storing the new

unit weight, press the CLEAR key.

5.11.4 Quick Add Item to Memory

The following procedure describes the steps used to add an item code to memory directly from the operation

mode, without switching to programming mode.

Note: To enable the quick add function, SPEC 04 SET NEW ITEM DURING OPERATION MODE must be set to “0: YES”.

1. After the item code has been entered, press the CODE key to store the new code. The display will briefly

show the message

SET NEW ITEM (NOT SAVE) before returning to the Stand-by screen.

2. Place a 10 piece sample on the scale and press the

PIECES key or use the numeric keypad to enter known

weight value (refer to Section 5.3.1 on page 37). Press the

UNIT WEIGHT key a second time to store the

weight value into the item code memory. The display will flash briefly, then return to normal. The unit

weight is now stored. To exit without updating the unit weight for this item code, press the

CLEAR key.

3. To set a tare value, enter the tare from the numeric keypad, press the

TARE key to identify the value, then

press the

UNIT WEIGHT key to store the tare with this item code.

4. When ready to return to the operation or stand-by mode, press the

CLEAR key.

5. To recall the item that has been stored via quick add, enter the item code and press the

CODE key.

Inventory

Threshold

Set Point

Press >> to view Set Point 2, << to return to Set Point 1

Address Number

Lot Number

Sequence Number

Key Stroke Description

Table 5-1. Item Codes