Specifications

26 DC-200/300 Operation Manual
2. The scale display will next indicate that it is ready for the data transfer mode after the scale is restarted.
Turn the scale off and then on again, using the on/off switch located on the bottom of the scale at the
back.
3. After you restart the scale and it goes through its startup sequence, the scale will show that the data
transfer mode is ready.
4. On your computer, open the Spec Upload program.
Note: If you have not yet installed the DC-300 Utility Program, see Section 6.2.2 on page 54.
At the opening screen of the Spec Upload program, you have the option to Load the Default Setting file; load
from a named, saved file on your computer; or read the spec settings from the DC-200/300 scale connected to
your computer.
Select the radio button for
Read From Scale. Also make sure that the Scale No. radio button for 192.168.0.1 (the IP
address of the DC-300) has been selected if you are using the DC-300 or 192.168.0.2 if you are using the
DC-200.
Figure 3-1. Read From Scale Screen
5. Click on the Next button at the bottom of the Spec Setting dialog box. The program will confirm Spec
reading in progress, please wait..., showing that it is uploading the current spec settings from the scale. The
Spec Upload program will next display the Spec Setting screen, showing the values of the first four
SPECs programmed in the scale.