Specifications

Installation 11
REPRINT
key to store the data in temporary memory and move to the time programming mode.
3. Enter the current time using the numeric keypad. For numbers from 1 to 9, enter a leading zero. (Ex. In a
12 hour format, 3:06 pm would be entered as 0306.) If SPEC 06 - TIME FORMAT is set to a 12 hour
format, you use the
<< and >> keys to toggle between AM and PM.
4. Press the
CODE key to save the data or press the PIECES key followed by the CLEAR key to exit without
saving the data.
5. To return to the Stand-by Screen in the Operation Mode, press the
MODE key three times.
2.6 Battery Installation (DC-200 only)
This section covers the installation of the DC-200’s battery into the battery compartment. Use the following steps
to install a battery into the DC-200.
Do not turn the scale upside down. Always work with the scale on its side! Damage to the load cell can
occur if the scale is turned upside down.
1. Turn the DC-200 on its left side.
2. Unscrew the three screws holding on the side cover to the battery compartment.
Figure 2-4. DC200 Screw Location
3. Remove the side cover enclosing the battery compartment.
Figure 2-5. Side Cover Location
#AUTION
Screw Location
Side Cover