Specifications

Appendix 139
12.4.7 Programming the QuickScan Keyboard Wedge Scanner
If you are using the Quickscan keyboard wedge barcode scanner connected to the IBM keyboard port, scan the
following barcodes to set up your scanner to communicate with the DC-200/300.
1. Set to RS232 Default Values
warning: use this barcode with
caution because it will clear any
features you may have programmed
since the scanner’s installation and
reset them all to the defaults.
2. Set Keyboard Type to “E”
(AT, PS2 W/US Keyboard)
Set
E
End
3. Set Keyboard Attached and
send control characters enable
Set
Keyboard
Attached
End
4. Set Interchange Delay
(40 milliseconds)
Set
40 ms
End