Specifications

Reports 111
9.5 Programming Reports (DC-300 only)
9.5.1 Factory Name Report (DC-300 only)
To check what factory names are already programmed into the scale and see what factory name files are still
available, follow the instructions below to print a report of the factory name file. You can print a factory name
report for a single name or for all the names that are programmed. See Section 7.2.1 on how to program a factory
name.
Before printing the report, please make sure that the DC-200/300 printer is loaded with receipt paper rather than
labels (see Section 7.1.4 on setting up the printer).
1. From the Stand-by screen press
the MODE key until the display shows ITEM CODE PROGRAMMING. The S
annunciator, indicating the programming mode, will illuminate.
2. Press the
+ key once to reach the FACTORY PROGRAMMING mode.
3. To print the report for a single factory name, enter the number for the factory name file you want to print
and press the
TARE key. To print the report for all factory names in memory, enter a 0 (zero) for the
factory number and press the
TARE key. To stop the printing at any time, press the FEED key. The report
will show the date and time it was printed, the factory number, and the font size and number of
characters on each line (see Section 7.1.3 for font sizes).
Figure 9-7. Factory Name Report