Specifications

DC-190 RS-232 SPECIFICATION (continued)
6.6.3.3. CONNECT TO LP2622, 2742, 2722
DC190 can connect to LP2622 printer.
Set the following Specs:
Baud Rate 9600 b
p
s
(
S
p
ec 10 bits 0 & 1
)
Stop Bit 1 bit (Spec 11 Bit 3)
Data Length 8 bits (Spec 10 Bit 2) Printer LP2622 (Spec11 Bit 2)
Parity None (Spec 11 Bit 0 & 1) RS232 Out
p
ut B
y
* , + & -Ke
y
(
S
p
ec 12 Bit 3 & 2
)
Note:
DC190 will download some label formats to LP2622 when power up. Owing to this, LP2622 should
connect to DC190 when DC190 power up. Also, make sure the printer has enough memory
allocated for Form Memory (at least 3K). Please refer to the printer manual.
Eltron printer 2622 9 pin “D” sub to 9 pin “D” sub.
Bit 3 Bit 2 Bit 1 Bit 0
Spec 3 0 0 0 0
Spec 10 1 1 1 1
Spec 11 0 0 0 0
Spec 12 1 0 0 (fixed format) 0
Spec 12 1 0 1
(
custom down load
)
0
Spec 13 0 0 1 (with P/C) 1
Or without PC
Spec 13 0 0 0 1
6.6.3.4. CONNECT TO EPSON TM-200
DC190 can connect to Epson tm-200 printer.
Epson TM - 200 printer 25 pin “D” sub to 8 pin “DIN” .
Bit 3 Bit 2 Bit 1 Bit 0
Spec 3 0 0 1 0
Spec 10 1 1 1 1
Spec 11 0 1 0 0
Spec 12 1 0 0 0
Spec 13 0 0 1(with P/C) 1
Or without PC
Spec 13 0 0 0 1
6.6.3.5. Connect to EPSON TM-200 using 9 pin “D” sub connector and BCP-30 (SE250)
using 8 pin din connector. With both printer printing at the same time.
Bit 3 Bit 2 Bit 1 Bit 0
Spec 3 0 1 0 0
Spec 8 0 1 1 1
Spec 9 0 1 0 0
Spec 10 1 1 1 1
Spec 11 0 1 0 0
Spec 12 1 0 0 0
Spec 13 0 0 1 1