Specifications

6.3. Spec 141 Setting: Spec 141(Customer Specifications) can be accessed from the weighing mode.
Refer to pages 38 & 39 for a list of specs.
1. Enter [1][4][1] while depressing the [REZERO] key.
2. [++
++
] key increases to the next SPEC number and also stores temporarily the SPEC data in the RAM
location.
3. Enter 1011 as the new value for SPEC01 using the [Numeric] keypad
4. [CLEAR] key clears the [Numeric] entry.
5. [++
++
] key increases to the next SPEC number.
6. [−−
−−
] key decreases to the previous SPEC number.
7. [−−
−−
]key decreases from SPEC 01 to SPEC 00.
8. [−−
−−
] key decreases the SPEC number from SPEC00 to SPEC19
9. [""
""
PROG] stores the new SPEC values to the NOV-RAM and exits from the SPEC setting mode.
10. Press [MODE] key to escape from maintenance mode to weighing mode.
NOTE: !!
!!
When making any spec changes it is necessary to follow this steps:
1. Advance to the next spec by pressing [+] key to store the changes into the temporary register.
2. Press [#ProG] to save the changes.
3. Turn scale off and on to allow the scale to permanently update all newly changed specs.
6.4. Spec 142 Setting: To access the Spec 142 (W & M Spec) mode the procedure is
similar to Spec 141 setting. Refer to pages 40 & 41 for a list of W &M specs.
1 Enter [1][4][2] while depressing the [REZERO] key.
2 [++
++
] key increases to the next SPEC number and also stores temporarily the SPEC data in the RAM
location.
3 Enter, (example, 1011) as the new value for SPEC21 using the [Numeric] keypad
4 [CLEAR] key clears the [Numeric] entry.
5 [++
++
] key increases to the next SPEC number.
6 [−−
−−
] key decreases to the previous SPEC number.
7 [−−
−−
]key decreases from SPEC 21 to SPEC 20.
8 [−−
−−
] key decreases the SPEC number from SPEC20 to SPEC36
9 [##
##
PROG] key stores the new SPEC values to the NOV-RAM and exits from the SPEC setting mode.
10 Press [MODE] key to return to the weighing mode.
NOTE: !!
!!
When making any spec changes it is necessary to follow this steps:
1. Advance to the next spec by pressing [+] key to store the changes into the temporary register.
2. Press [#ProG] key to save the changes.
3. Turn scale off and on to allow the scale to permanently update all newly changed specs.