Specifications

4.11. To Set New Item Code In Normal Operation:
(Example: During Normal Weighing Mode, New Item Code No. 246 Is Required)
This operation is valid only when the Spec Set New item in
Normal Operation Is enabled.
1 Press new code no. example : enter [2] [4] [6]
2 Press [CODE] key
3 Press [CODE] key to set the new code no. Into memory
4 Enter unit weight See pg. 11& 4.3.1. & 4.3.2.
5 Press the [UNIT WEIGHT] key enter into memory
* If the new data is not required to be set in the memory, depress clear key after “not F” is
displayed.
4.12. Inventory Operation:
Inventory In
1 Press [CODE] key until Indicator IN is lit.
2 Enter ID Code. example: [1][2][3][4] (This item must already be programmed into
the memory of the scale)
3 Press [CODE] key
4 Place weight on the platter.
5 Press [∗∗
∗∗
] key. This Recalculates “QUANTITY IN STOCK” by adding the
Quantity
Inventory Out
6 Press [CODE] key until Indicator OUT is lit
7 Enter ID Code. example: [1][2][3][4]
8 Press [CODE] key
9 Place weight on the platter.
10 Press [∗∗
∗∗
] key. This Recalculates “QUANTITY IN STOCK” by deducting the
Quantity
11 Remove weight
12 Press [NET /GROSS] Key. Check Quantity in Stock