Specifications

4.0 OPERATION GUIDE IN WEIGHING MODE
4.1 Tare Reduction :
4.1.1 One Touch Tare Operation :
All weights listed in these instructions are for example only use smaller weights for lower capacity
scales!
1 Display in the weighing mode
2 Place 0.5 Lb weight on the platter. (Example : of a .5lb tare)
3 Press the [TARE] key to tare the weight on the platter
4 Remove the weight from the platter
4.1.2. Digital Tare Operation :
1 Display in the weighing mode.
2 Enter [0][.][5][0][0][0] (Example : of a .5lb tare)
3 Press the [TARE] key to tare the weight entered by keyboard.
4.2 Net/Gross Operation :
1 Display in the weighing mode.
2 Place 0.5 Lb. weight on the platter.
3 Press the [TARE] key to tare the weight on the platter.
4 Place an additional 0.5 Lb. on the platter.
5 Press the [NET / GROSS] key. 1.0000 lb is the Gross Weight.
6 Press the [NET / GROSS] key. 0.5000 lb is the Net Weight.
4.3 Unit Weight Operation :
4.3.1 Unit Weight Operation by Sampling :
1 Display in the weighing mode
2 Place 10 pcs of the item to be sampled on the platter.
3 Press the [PIECES] key. Please wait for a few seconds for the computation.
4 The Unit Weight Display shows the Unit Weight of the samples (1.255/1000 pieces) and the
Quantity Display shows the Quantity of the pieces i.e. 10 in this case.
Note : If the insufficient lamp is “ON”, when the sample pieces are placed on the platter, add a few
more pieces until the Insufficient lamp is “OFF. Enter the no. of pieces using the keyboard and press the
[
PIECES
]
ke
y
. For exam
p
le : After
p
uttin
g
ten
p
cs. on the scale as a sam
p
le, if the insufficient lam
p
is
“ON”, add a few more
p
ieces
(
ex. 3
)
until the insufficient lam
p
is “OFF”. Now usin
g
the ke
y
board,
enter [1][3] and then press the [PIECES] key to compute the unit weight of the samples.