Specifications

43
IN / OUT / NON-ADD ENTRY TO ID CODE
21. Enter Auto job pattern number. 1
i.e.) Auto job number in. ( 1 )
receiving operation
. . . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R I M I O 1 2 3 4 5 6 7 8
22. Press [ SHIFT ↓
↓↓
↓] key then [H /
IN
]
* 0.00 0. 0
key within 3 seconds.
∇
∇∇
∇ ∇
∇∇
∇ ∇
∇∇
∇ ∇
∇∇
∇
(
Ready for setting the other item data)
. . . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R I M I O 1 2 3 4 5 6 7 8
NOTE) *
"
Auto job no. can be selected from 5 patterns which are programmed in Maintenance mode.
* "
You can select Auto Job no. for shipping to check operations with the same pattern as the
above except using [ I/ OUT] or [ J /NON-ADD] key instead of [ H/IN ] key.
* "
If auto job number is not assigned for ID code, auto jobs are according to address 4,5,6 of
“MISC SPEC.”
TO ENTER TARE VALUE TO ID CODE TWO
WAYS
Un-known tare weight
23. Place tare weight on the platter * 0.5 0. 0
(i.e. 0.500)
∇
∇∇
∇ ∇
∇∇
∇
. . . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R I M I O 1 2 3 4 5 6 7 8
24. Press [TARE/←
←←
← ] key.
* 0.00 0. 0
∇
∇∇
∇ ∇
∇∇
∇ ∇
∇∇
∇ ∇
∇∇
∇
OR . . . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R I M I O 1 2 3 4 5 6 7 8
Known tare weight
(23) Enter tare weight value with numeric key. (3) 0 . 5 0
(i.e. 0.50)
. . . . . . . . . . . . . . . . . . . . .
Z S N K 1 2 3 I R I M I O 1 2 3 4 5 6 7 8
(24) Press [TARE /←
←←
← ] key.
- 0.50 0.0 0
∇
∇∇
∇ ∇
∇∇
∇ ∇
∇∇
∇ ∇
∇∇
∇
. . . . . . . . . . . . . . . . . . . . .
Z S T K 1 2 3 I R I M I O 1 2 3 4 5 6 7 8
.
Note) " To clear tare weight, press [0] and [TARE ] key.