Specifications

15
8.
LABEL & PAPER ROLL SET UP
1. Remove front panel of printer.
2. Release thermal head block by pulling down the plastic lock.
3. Open the right side door of printer block by pushing in panel & releasing.
4. Pull out label cassette from the main unit.
5. Twist the roll holder s 45 degree clockwise and pull it out to remove.
6. Take out the empty roll core and replace with a new roll.
7. In case of label, take the end of the label stock and run it above the guides o and through
dispenser p and lock backing paper on take up reel q with paper clampr.
8. Replace by pushing roll holder sinto set reeln as drawing, until it stops.
9. Set label and paper switch on the inside of label cassette.
[LEFT (label) ↔ RIGHT(paper)]
10.Slide cassette into the main unit, align the metal dispenser p shaft under the thermal
head.
11.Close the thermal head block by pushing the top of the plastic lock.
12.Close the side panel and replace the front panel of printer.
13. Align & adjust tension of the label roll by pressing [→
→→
→] (feed) Key
14. In the case of paper, install paper roll the same as label stock
15. Fold the end of the paper and hold the fold on dispenser p .
16. Replace the cassette into the main unit and close the thermal head block the same as
label stock.
17. Align the paper by pressing [→
→→
→] (feed) key