User`s guide

Monitoring capabilities from the command line
205
Monitoring capabilities from the command line
There are several commands for monitoring Digi devices and managing their connections. For
complete descriptions of these commands, see the Digi Connect Family Command Reference.
Commands for displaying device information and statistics
display commands
display commands display real-time information about a device, such as:
 General product information, including the product name, MAC address, boot, post, and
firmware versions, memory usage, utilization, and uptime, or the amount of time since
the device was booted (display device).
 Active interfaces on the system, for example, the web interface, command line interface,
Point to Point Protocol (PPP), and Ethernet interface, and their status, such as “Closed”
or “Connected.” (display netdevice).
 The event log (display logging).
 Memory usage information (display memory).
 Serial modem signals. (display serial).
 Mobile connection information and statistics (display mobile).
 Network Address Translation (NAT) information (display nat).
 General status of the sockets resource (display sockets).
 Active TCP sessions and active TCP listeners (display tcp).
 Current UDP listeners (display udp).
 Point-to-Point Protocol (PPP) information, including results of Link Integrity
Monitoring tests by Digi SureLink “display pppstats”).
 Provisioning information currently in the Digi device device’s CDMA module (display
provisioning)
 Uptime information (display uptime).
 Virtual Private Network (VPN) connection information (display vpn).