User`s manual

Configure the Gateway

Connect and Power on the ConnectPort X2

1. Unpack the ConnectPort X2 for Smart Energy gateway.

2. Connect the power supply to the X2 gateway and connect the power supply to an

electrical outlet.

Note: (International version only): Connect the power supply to a power cable (not included),

and the power cable to an outlet.

3. Connect an Ethernet cable from the gateway to your hub or switch that provides

access to the Internet.

Point Gateway to developer.idigi.com

By default, your Connectport X2 gateway points to energy.digi.com. This is our

production server. For your development purposes, you can have up to five devices

added to your account at developer.idigi.com.

Note: Older versions of the gateway may instead be pointed to device.digi.com. Use the same

following steps to redirect the gateway to the correct server.

To configure your gateway properly, point the device to developer.idigi.com in the

following manner:

1 Use the Digi Device Discovery application (see “Resources” on page 7) to determine your

gateway’s IP address.

2 Telnet to this address, then type in the following commands:

password: dbps

#> set mgmtconnection svraddr1=”http://developer.idigi.com” conntype=client

This will tell the gateway where to look for a server, specifically “http://

developer.idigi.com. Now, type the “who” command to get the number of the process

currently controlling where the gateway points. In this case, it’s process ID 1. Kill this

process, as shown below.

#> who

ID From To Protocol

1 10.8.16.83:45627 67.202.55.55:3197 idigi tcp

2 Python: main.py

3 10.8.16.85 local shell telnet

4 Python thread