User`s guide

Administration from the web interface
219
ConnectPort X8 has the Reset button on the front panel.
3 Hold the Reset button down gently with a non-conductive, small diameter tool (such as
wood or plastic) with a blunt end (NOT SHARP or the button could be damaged). Power on
the device while holding the Reset button down.
On some models, after a few seconds you may see the Status LED blink a 1-1-1 pattern
once.
4 After 30 seconds, release the Reset button. At this point, on some models, the Status LED
will blink a 1-5-1 pattern.
5 Wait for the device to boot up. At this time, the configuration is returned to factory defaults.
6 Now, if desired, power off the device, though this is not necessary. Powering off the device
before releasing the button guarantees the configuration will NOT be reverted. Powering off
the device just after releasing the button will result in an unknown configuration, possibly
having some or all settings reverted to defaults.
Status
LED
Cellular
Link &
Activity
LEDs
Cellular
SinLEDs
XBee Link
& Activity
LEDs
Primary
Cellular
Antenna
Connector
XBee
Antenna
Connector
Wi-Fi
Antenna
Connector
(optional)
Reset
button
Secondary
Cellular
Antenna
Connector
(dual
diversity)
Power input
9-30 VDC
Wi-Fi Link
& Activity
LEDs
Power
LED
Cellular
Signal
Strength
LEDs